Elektra  0.8.25
kdb-check(1) -- Perform internal checks

kdb check [<plugin>]

DESCRIPTION

This command is used to perform checks on the key database or an Elektra plugin.

Where the option argument, plugin is the plugin that a user wants to check. Use -c to pass options to that plugin. If no plugin argument is provided a check will be performed on the key database itself. Special values are returned upon exit to represent the outcome of a check.

OPTIONS

RETURN VALUES

There are two different types of checks, a check on a plugin (by specifying the name of a plugin as an argument) or a check on the key database itself.

The outcome of a check on the key database is returned as an exit status. This integer represents an 8-bit pattern. Each bit represents a specific outcome as described below:

So if the following number was returned 9 the user could figure out more detail by considering the bits: 00001001 The user would know that there was a warning on open and an error on get.

If a plugin name is given, checks will only be done on the given plugin. The returned values for a check on a plugin are returned as much simpler numbers.

Return values on plugin checking:

Please report any output caused by official plugins to https://git.libelektra.org/issues.

Since the error code is a return value, it is not automatically displayed to the shell. If the user wants to have the value printed, they must do so manually (by running a command such as echo $?).

EXAMPLES

To check the Key Database:
kdb check

To check the Key Database and then print the result:
kdb check followed by:
echo $?

To check the Key Database including write checks:
kdb check -f Note that this type of check may change configuration files.

To check the line plugin:
kdb check line

SEE ALSO