Plugin: enum

• infos = Information about the enum plugin is in keys below
• infos/author = Thomas Waser thoma.nosp@m.s.wa.nosp@m.ser@l.nosp@m.ibel.nosp@m.ektra.nosp@m..org
• infos/licence = BSD
• infos/provides = check
• infos/needs =
• infos/recommends =
• infos/placements = presetstorage postgetstorage
• infos/status = unittest tested nodep libc obsolete
• infos/metadata = check/enum check/enum/# check/enum/multi
• infos/description = validates values against enum

This plugin is obsolete: Please use the type plugin instead.

The enum plugin checks string values of Keys by comparing it against a list of valid values.

Usage

The plugin checks every Key in the Keyset for the Metakey check/enum containing a list with the syntax `'string1', 'string2', 'string3', ..., 'stringN'` and compares each value with the string value of the Key. If no match is found an error is returned.

Alternatively, if check/enum starts with #, a meta array check/enum is used. For example:

check/enum = #3
check/enum/#0 = small
check/enum/#1 = middle
check/enum/#2 = large
check/enum/#3 = huge

Furthermore check/enum/multi may contain a separator character, that separates multiple allowed occurrences. For example:

check/enum/multi = _

Then the value middle_small would validate. But middle_small_small would fail because every entry might only occur once.

Example

# Backup-and-Restore:/tests/enum

sudo kdb mount enum.ecf /tests/enum enum dump

# valid initial value + setup valid enum list
kdb set /tests/enum/value middle
kdb setmeta /tests/enum/value check/enum "'low', 'middle', 'high'"

# should succeed
kdb set /tests/enum/value low

# should fail with error 04200
kdb set /tests/enum/value no
# RET:5
# ERROR:C03200

Or with multi-enums:

# valid initial value + setup array with valid enums
kdb set /tests/enum/multivalue middle_small
kdb setmeta /tests/enum/multivalue check/enum/#0 small
kdb setmeta /tests/enum/multivalue check/enum/#1 middle
kdb setmeta /tests/enum/multivalue check/enum/#2 large
kdb setmeta /tests/enum/multivalue check/enum/#3 huge
kdb setmeta /tests/enum/multivalue check/enum/multi _
kdb setmeta /tests/enum/multivalue check/enum "#3"

# should succeed
kdb set /tests/enum/multivalue ___small_middle__

# should fail with error 04200
kdb set /tests/enum/multivalue ___all_small__
# RET:5
# ERROR:C03200

# cleanup
kdb rm -r /tests/enum
sudo kdb umount /tests/enum

Limitations

You cannot give enum values specific values. If you only want to check for numerical values, the plugin range is better suited.